Installing the
New Head
DOC-13025 Rev. A
13. Inspect the replacement head, and make sure that the O‐ring seals are
in place (see figure 6‐61).
14. Gently insert the replacement head into the vacant slot in the print
block, and push the print‐head driver card into its socket.
Note: Make sure to insert the head with the driver card facing its socket, in
the rear of the print block.
Figure 6-63: Inserting the print-head driver card into its socket
15. Push the head up until you hear it click into place, in both front and
rear holders.
Figure 6-64: Clicking the head into place in the print block
16. Lower the door of the print head compartment, and tighten the screws
to lock it in place.
17. Tighten the upper and lower screws that secure the print head in the
print block (see figure 6‐57 on page 42).
Note: Hand-tighten these screws. Do not use a screwdriver or hex (Allen
key.
Connex500/350 User Guide
®
)
6–45