Table of Contents
Advertisement
DOC-13025 Rev. A
Figure 5-10: Assembly check box selected—stl files are placed as an assembly
Figure 5-11: Assembly check box not selected—stl files are placed as parts
The Model Settings ribbon is displayed when objects are placed on the
build tray.
5. Select any of the following options, as required:
•
—Millimeters or inches for the object's units of measure.
Units
The 3D file contains the objectʹs proportions, but not its units of
measure. Therefore, make sure to correctly select either
or
when inserting an object. Otherwise, the size of the object
inches
on the build tray will be either much too large or much too small. To
change the measurement units of objects already placed on the tray,
see "Measurement Units" on page 32.
•
Number of copies
build tray.
•
Orient Automatically
for efficient model building.
•
—Mark this check box if you selected multiple stl files that
Assembly
are part of an assembly.
Connex500/350 User Guide
—How many copies of this object to place on the
—Automatically orient objects on the build tray
millimeters
5–11
Advertisement
Table of Contents
