Table of Contents
Advertisement
Operating & Maintaining the Connex500/350 3D Printer
UV sensor
connected to printer
6–52
The following steps apply when using the Stratasys UV sensor that you
connect to the printer. They do not apply when using a stand-alone UV
radiation measuring device.
1. Adjust the wizard for the sensitivity of the UV sensor by entering the
CF number that appears on the sensor's label.
Figure 6-76: UV sensor synchronization
Figure 6-77: Label on the bottom of the UV sensor
The build tray lowers so you can connect the UV sensor.
Figure 6-78: UV sensor connector
DOC-13025 Rev. A
Advertisement
Table of Contents
