Table of Contents
Advertisement
Operating & Maintaining the Connex500/350 3D Printer
Command Buttons You click the command buttons, on the right side of the screen, to perform
Summary On the right side of the screen, a symbol represents the combined results of
6–66
the following operations:
Run
Click to run the selected tests.
Reset
Click to clear previously run tests. This returns the status of each test to
Unknown (?).
Save
Click to save a report that summarizes the tests run. The report is saved as
an HTML file. You can save any number of reports for the tests you run; the
name of the file saved is
are saved in the Connex installation folder, but you can save it in any other
folder.
View
Click to display the latest test report that you saved. (You can view other
test reports by opening the relevant files in your Web browser. To do so,
open Windows Explorer, and double click the BITReport file.)
Close
Click to close the Built‐in Tests screen.
all the tests run, using the symbols from the Status column.
All tests successfully completed.
At least one test failed.
Not all tests performed.
BITReport [date][time].htm
. By default, these files
DOC-13025 Rev. A
Advertisement
Table of Contents
