Improving Print Quality - Stratasys Connex500 User Manual

Table of Contents

Advertisement

Operating & Maintaining the Connex500/350 3D Printer
Improving
Print Quality
6–28
Figure 6-33: Sample Pattern Test
6. Carefully inspect the test paper to see if there are missing lines. 
Too many missing lines, especially if they are in the same area, 
indicates that the quality of printing when producing models will be 
poor. If this is the case, see "Improving Print Quality," below.
Note: Acceptable model quality is subjective, and depends on the type
and scale (size) of the models produced. As a rule, however, more than 10
missing lines in one area of a column is considered unacceptable.
If you suspect that print quality is poor, perform the pattern test (see 
"Pattern Test" on page 27). If the results are poor, use the following 
procedure to improve print quality.
If the results of the last pattern test are poor:
1. From the Options menu, select 
2. In the confirmation dialog box, click 
The print heads are purged of Model and Support material, and the 
wiper removes excess material from them.
3. Repeat the purge sequence.
4. Perform the pattern test.
If the results of the pattern test are still poor:
1. Manually clean the print heads (see "Cleaning the Print Heads and the 
Roller" on page 22).
2. Perform the purge sequence.
3. Perform the pattern test.
If the results of the pattern test are still poor:
1. Carefully clean the print heads again, making sure there is no residue 
left on them.
2. Perform the purge sequence.
3. Perform the pattern test.
If the results of the pattern test are still poor:
Optimize the print heads and replace faulty print heads, if necessary 
(see "Calibrating (Optimizing) Print Heads" on page 38).
, or press 
Purge Sequence
.
Yes
.
F4
DOC-13025 Rev. A

Advertisement

Table of Contents
loading

This manual is also suitable for:

Connex350

Table of Contents