Table of Contents
Advertisement
Operating & Maintaining the Connex500/350 3D Printer
6–26
Confirm this in the wizard screen and click
Figure 6-28: Wiper Cleaning procedure—step 4
5. When the following screen appears, open the cover.
Figure 6-29: Wiper Cleaning wizard during steps 6–9
6. Put on the cleaning gloves.
7. Using a generous amount of alcohol on the cleaning cloth, remove any
material remaining on the wiper and the surrounding area.
8. Inspect the wiper.
If the wiper is scratched, torn or worn, or if you cannot clean it
completely, replace it.
a. Grasp it and pull it up and out of its bracket.
b. Insert the new wiper blade, making sure that it is straight and secured
well on both sides.
9. In the wizard screen (see figure 6‐29), confirm that the wiper blade is
clean, and click
Next
10. Remove all tools and cleaning materials from the printer, and close the
cover.
.
.
Next
DOC-13025 Rev. A
Advertisement
Table of Contents
