Operating & Maintaining the Connex500/350 3D Printer
Installation
Problems
6–48
If the printer detects that there is a problem after you install print heads,
relevant warning screens appear.
If the printer software does not detect the replaced head, the following
warning screen appears.
Figure 6-70: Incorrect-installation screen
If this happens:
a. Open the print head compartment (see figure 6‐59 on page 43).
b. Re‐insert the print‐head driver card into its socket (see figure 6‐63
on page 45).
c. In the wizard screen, select the check box to confirm that you have
re‐inserted the card, and click
If the replacement head was not factory‐calibrated, the following
warning screen appears.
Figure 6-71: Invalid-data warning screen
If this happens:
a. Remove the head and replace it with another one (starting with
step 8 on page 42).
b. In the wizard screen, select the check box to confirm that you have
installed another print head, and click
c. Contact your authorized Customer Support center about the
unformatted head.
.
Next
.
Next
DOC-13025 Rev. A