Stratasys Connex500 User Manual page 88

Using Objet Studio
5–52
If you allow the use of substitute model materials, the printer will use
different materials whose characteristics (strength, flexibility, etc.) are
similar to those of the material you assigned to the object when
designing the build tray—under the following conditions:
•
The material you assigned is not installed in the printer at the time
of printing.
In this case, the tray is printed with either one or two substitute
materials (depending on the materials installed in the printer at the
time of printing). If possible, High Speed mode is used.
•
In addition to the material you selected, there is another (similar)
material installed in the printer at the time of printing.
In this case, High Speed mode is used, by printing with a mixture of
the two materials (as if they were the same material).
4. Click .
Build
If the build tray file has not been saved, the Save As dialog box opens for
you to save it now.
Objet Studio checks if there is a problem with the positioning of objects
on the tray. If so, the affected objects are displayed with special colors
(see "Tray Validation" on page 47), and a warning message appears.
Figure 5-74: Tray validation warning message
•
To cancel the Build command so you can correct the problem, click
.
No
•
To print the models as they are positioned on the tray, click
The Job Manager screen opens, so you can monitor the progress of your
trays—before, during, and after printing. See "Monitoring and
Managing Print Jobs" on page 70.
.
Yes
DOC-13025 Rev. A