DOC-13025 Rev. A
13. Continue as follows:
•
To make the alignment changes in the printer, make sure that Yes is
selected, and click
•
To recheck the alignment test results before making the alignment
changes in the printer, click
•
If you do not want to make alignment changes in the printer at this
time, select No and click
14. In the following screen, you can choose to either repeat the head
alignment procedure or close the wizard.
•
If the most closely aligned vertical lines for a print head were at
either extreme—the first or seventh lines—choose Yes to run the
Head Alignment wizard again, then click
The transparency test will show if the heads are now properly
aligned, and—if not—the wizard will allow you to "fine tune" the
alignment.
•
If the vertical lines for the print heads were not aligned at either
extreme, choose No to close the wizard, then click
Figure 6-51: Repeat head alignment option
Connex500/350 User Guide
.
Next
.
Previous
.
Next
.
Next
.
Next
6–37