Contents Of This Chapter; Terms And Abbreviations - ABB ACS880 Firmware Manual

Additional parameter data

Contents of this chapter

This chapter lists the parameters with some additional data. For parameter
descriptions, see chapter

Terms and abbreviations

Term Definition
Actual signal Signal measured or calculated by the supply unit. Usually can only be monitored but
not adjusted; some counter-type signals can however be reset by entering the value
0.
Analog src Parameter can be set to the value of another parameter by choosing Other, and
selecting the source parameter from a list.
In addition to the Other selection, the parameter may offer other pre-selected
settings.
Binary src Value of the parameter can be taken from a specific bit in another parameter value
(Other). Sometimes the value can be fixed to 0 (False) or 1 (True).
In addition to the Other, False and True selections, the parameter may offer other
pre-selected settings.
Data Data parameter.
FbEq32 32-bit fieldbus equivalent: Scaling between the value shown on the panel and the
integer used in fieldbus communication when a 32-bit value is selected for
transmission to an external system.
Corresponding 16-bit scalings are listed in chapter
List Selection list.
No. Parameter number.
Parameters (page 39).
Additional parameter data 139
6
Parameters (page 39).