ABB ACS880 Firmware Manual page 105

No. Name/Value
133.32 Edge count 1 func
Bit Function
0 Counter mode
0 = Loop: If warning is enabled by bit 1, it stays active only for 10 seconds
1 = Saturate: If warning is enabled by bit 1, it stays active until reset
1 Warning enable
0 = Disable: No warning is given when the limit is reached
1 = Enable: A warning is given when the limit is reached
2 Count rising edge
0 = Disable: Rising edges are not counted
1 = Enable: Rising edges are counted
3 Count falling edge
0 = Disable: Falling edges are not counted
1 = Enable: Falling edges are counted
4...15 Reserved
0000h...FFFFh
133.33 Edge count 1 src
False
True
RO1
Other [bit]
133.34 Edge count 1 div
1...4294967295
133.35 Edge count 1 warn
sel
Edge count 1
Main contactor
Output relay
Supply unit starts
Power ups
DC-charge
133.40 Edge count 2 act
0...4294967295
133.41 Edge count 2 limit
0...4294967295
Description
Configures signal edge counter 1. This counter is
incremented every time the signal selected by
parameter 133.33 Edge count 1 src
either, depending on the setting of this parameter). A
divisor may be applied to the count (see
count 1 div).
After the limit set by 133.31 Edge count 1 limit
the warning specified by
given (if enabled by this parameter), and the counter
reset.
The current value of the counter is readable from
parameter 133.30 Edge count 1
Counter status indicates that the count has exceeded
the limit.
Edge counter 1 configuration word.
Selects the signal to be monitored by signal edge
counter 1.
Constant 0.
Constant 1.
Bit 0 of 110.21 RO status
Source selection (see Terms and abbreviations
39).
Divisor for signal edge counter 1. Determines how many
signal edges increment the counter by 1.
Divisor for signal edge counter 1.
Selects the warning message for signal edge counter 1.
AE47 Edge counter 1.
AE43 Main contactor warning.
AE40 Output relay warning.
AE41 Supply unit starts
AE42 Power ups warning.
AE44 DC charge warning.
Reading of signal edge counter 2. Can be reset from the
Drive composer PC tool, or from the control panel by
keeping Reset depressed for over 3 seconds.
Reading of signal edge counter 2.
Sets the warning limit for signal edge counter 2.
Warning limit for signal edge counter 2.
switches on or off (or
133.34 Edge
is reached,
133.35 Edge count 1 warn sel
act. Bit 2 of 133.01
(page 55).
warning.
Parameters 105
Def/FbEq16
0000b
is
1 = 1
False
0
1
2
on page -
1
1= 1
Edge count 1
2
11
12
13
14
15
-
1 = 1
0
1 = 1