ABB ACS880 Firmware Manual page 133

No. Name/Value
195.20 HW options word 1
Bit Name
0...10 Reserved
11 INU-DSU
communication
12 Reserved
13 DOL fan
14 DIO1 for brake
chopper feedback
15 ACS880-307LC
0000h...FFFFh
195.30 Parallel type list
filter
All types
-3 (380-415V)
-5 (380-500V)
-7 (525-690V)
195.31 Parallel connection
rating id
Not selected
Description
Specifies hardware-related options that require
differentiated parameter defaults. Activating a bit in
this parameter makes the necessary changes in other
parameters. In many cases, the differentiated
parameters will also be write-protected.
This parameter, as well as the changes in other
parameters implemented by it, are not affected by a
parameter restore.
WARNING! After switching any bits in this word,
recheck the values of the affected parameters.
Information
Reserved
Enables DDCS communication with ACS880 inverter. Selects
DDCS controller as the control source, enables the
communication and configures required dataset parameters.
Sets parameter:
• 119.11 Ext1/Ext2 sel
• 120.01 Ext1 commands
• 160.51 DDCS controller comm port
• 160.52 DDCS controller node address
• 161.51 Data set 11 data 1 selection
• 162.51 Data set 10 data 1 selection
Reserved
Direct-on-line cooling fan is used instead of speed-controlled
cooling fan. Disables fan feedback monitoring and changes fan
control to ON/OFF type.
Sets parameter
131.39 Brake chopper fault source
DxT modules only: Sets parameter
• 111.05 DIO1 function
• 111.09 DIO2 function
• 131.32 Aux circuit breaker fault source
• 131.38 Fuse trip fault source
• 131.39 Brake chopper fault source
• 206.01 I/O bus enable to Yes,
• 206.50 MCB monitoring action to Fault,
• 206.51 Fuse monitoring action to No.
Hardware options configuration word.
DxT modules only: Filters the list of drive/supply unit
types listed by parameter
rating id.
All types listed.
-3 (380...415 V) types listed.
-5 (380...500 V) types listed.
-7 (525...690 V) types listed.
DxT modules only: Defines the drive/supply unit type if
it consists of parallel-connected modules.
If the drive/supply unit consists of a single module,
leave the value at Not selected.
The drive/supply unit does not consist of parallel-
connected modules, or type not selected.
to EXT1,
to DDCS controller,
to
to
to
111.05 DIO1 function to Input, and parameter
to DIO1.
to Input,
to Input,
to DIO2,
to DIO1,
195.31 Parallel connection
Parameters 133
Def/FbEq16
-
RDCO CH 0,
to 1,
SW 16bit,
CW 16bit.
to Inactive (true),
1 = 1
All types
0
1
2
3
Not selected
0