Volvo Edc4; Volvo-Ems2 - Smartgen HGM9600 Series User Manual

Terminals of controller
CAN GND
CAN(H)
CAN(L)
Engine type: Volvo.
NOTE: When this engine type is selected, preheating time should be set to at least 3 seconds.

15.17 VOLVO EDC4

Suitable engine types are TD520, TAD520 (optional), TD720, TAD720 (optional), TAD721, TAD722, and
TAD732.
Terminals of controller
Fuel relay output
Start relay output
CAN GND
CAN(H)
CAN(L)
Engine type: VolvoEDC4.

15.18 VOLVO-EMS2

Volvo Engine types are TAD734, TAD940, TAD941, TAD1640, TAD1641, and TAD1642.
Terminals of controller
Auxiliary output 1
Auxiliary output 2
CAN GND
CAN(H)
CAN(L)
HGM9600 Series Genset Controller User Manual
Table 43 "Data bus" Connector
"Data bus" connector
-
1
2
Table 44 Connector
Connector
Expanded 30A relay, and relay
offers battery voltage
terminal14. Fuse is 16A.
-
1
-
12
13
Table 45 Engine CAN Port
Engine's CAN port
6
5
3
4
-
1(Hi)
2(Lo)
Remark
CAN communication
(connect with
only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
for
Connect to starter coil directly.
Connected to negative of battery.
CAN communication
(connect with controller's terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
ECU stop;
Set Auxiliary output 1 as "ECU stop".
ECU power;
Set Auxiliary output 2 as "ECU power".
Negative power
Positive power
CAN communication
(connect with controller's terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
shielding line
controller's terminal
shielding line
shielding line
Page 67 of 73