Volvo Edc4; Volvo-Ems2 - Smartgen HGM7110DC User Manual

14.13
Suitable engine types are TD520, TAD520 (optional), TD720, TAD720 (optional), TAD721,
TAD722, and TAD732.
Terminals of controller
Fuel relay output
Start relay output
CAN GND
CAN(H)
CAN(L)
Engine type: VolvoEDC4
14.14
Volvo Engine types are TAD734, TAD940, TAD941, TAD1640, TAD1641, and TAD1642.
Terminals of controller
Auxiliary output 1
Auxiliary output 2
CAN GND
CAN(H)
CAN(L)
Engine type: Volvo-EMS2
NOTE: When this engine type is selected, preheating time should be set to at least 3
seconds.
HGM7110DC Genset Controller

VOLVO EDC4

Connector
Expand 30A relay; battery
voltage of terminal 14 is
supplied by relay. Fuse is
16A.
-
1
-
12
13

VOLVO-EMS2

Engine's CAN port
6
5
3
4
-
1(Hi)
2(Lo)
Version: 1.0
HGM7110DC Genset Controller
Remark
Connect to starter coil directly
Connected to negative of battery
CAN communication
line(connect with
terminal only)
Impedance 120Ω connecting line is
recommended.
Impedance 120Ω connecting line is
recommended.
Remark
ECU stop
Set Auxiliary output 1 as "ECU Stop"
ECU power
Set Auxiliary output 2 as "ECU
power"
Negative power
Positive power
CAN communication
line(connect with
terminal only)
Impedance 120Ω connecting line is
recommended.
Impedance 120Ω connecting line is
recommended.
2014-09-27
shielding
controller's
shielding
controller's
Page 66 of 68