Smartgen HGM9600 Series User Manual page 42

No.
28 Reserved
29 Close Generator
30 Open Breaker
31 Close Mains
32 Reserved
33 Start Relay
34 Fuel Relay
35 Idle Control
36 Raise Speed
37 Drop Speed
38 ETS Control
39 Pulse Drop speed
40 ECU Stop
41 ECU Power
42 Pulse raise speed
43 Crank Success
44 Generator OK
45 Generator Available
46 Mains OK
47 Reserved
48 Common Alarm
49 Common Trip and Stop
50 Common Shutdown
51 Common Trip Alarm
52 Common Warn Alarm
53 Reserved
54 Battery High Volts
55 Battery Low Volts
56 Charge Alt Fail
57 Reserved
58 Reserved
59 Reserved
60 ECU Warn
61 ECU Shutdown
62 ECU Comm. Fail
HGM9600 Series Genset Controller User Manual
Type
Control generator to take load.
Control generator to off load.
Control mains to take load.
Action when genset is cranking and disconnect when
stopped completely.
Used for engine which has idles. Close before starting and
open in warming up delay; Close during stopping idle mode
and open when stop is completed.
Action in warming up delay.
Action between the period from "stop idle" to "failed to stop".
Used for engines with ETS electromagnet. Close when stop
idle is over and open when pre-set "ETS delay" is over.
Active 0.1s when controller enter into stop idle, used for
control part of ECU dropping to idle speed.
Used for ECU engine and control its stop.
Used for ECU engine and control its power.
Active 0.1s when controller enter into warming up delay; used
for control part of ECU raising to normal speed.
Close when detects a successful start signal.
Action when generator is normal.
Action in period of generator ok to hi-speed cooling.
Action when mains normal.
Action when genset common warning, common shutdown,
common trips alarm.
Action when common trip and stop alarm.
Action when common shutdown alarm.
Action when common trips alarm.
Action in common warning alarm.
Action when battery's over voltage warning alarm.
Action when battery's low voltage warning alarm.
Action when charge failure warning alarms.
Indicate ECU sends a warning signal.
Indicate ECU sends a shutdown signal.
Indicate controller not communicates with ECU.
Description
Page 42 of 73