Table of Contents
Advertisement
11 COMMISSIONING
Please make the under procedures checking before commissioning,
1.
Ensure all the connections are correct and wires diameter is suitable.
2.
Ensure that the controller DC power has fuse, the controller's positive and negative connected to start
battery are correct.
3.
Emergence stop must be connected with positive of start battery via scram button's normal close
point and fuse.
4.
Take proper action to prevent engine to crank disconnect (e. g. Remove the connection wire of fuel
valve). If checking is OK, make the start battery power on; choose manual mode and controller will
executive routine.
5.
Set controller under manual mode, press "start" button, genset will start. After the setting times as
setting, controller will send signal of Start Fail; then press "stop" to reset controller.
6.
Recover the action of stop engine start (e. g. Connect wire of fuel valve), press start button again,
genset will start. If everything goes well, genset will normal run after idle running (if idle run be set).
During this time, please watch for engine's running situations and AC generator's voltage and
frequency. If abnormal, stop genset running and check all wires connection according to this manual.
7.
Select the AUTO mode from controller's panel, connect mains signal. After the mains normal delay,
controller will transfer ATS (if fitted) into mains load. After cooling time, controller will stop genset and
make it into "standby" mode until there is abnormal of mains.
8.
When mains power is abnormal again, genset will be started automatically and into normal running,
then controller send signal to making generator switch on, and control the ATS as generator load. If
not like this, please check ATS' wires connection of control part according to this manual.
9.
If there is any other question, please contact SmartGen's service.
HGM9600 Series Genset Controller User Manual
Page 53 of 73
Advertisement
Table of Contents
