14.17 VOLVO EDC4
Suitable engine types: TD520, TAD520 (optional), TD720, TAD720 (optional), TAD721, TAD722, and
TAD732.
Terminals of controller
Fuel relay output
Start relay output
CAN GND
CAN(H)
CAN(L)
Engine type: VolvoEDC4
14.18 VOLVO-EMS2
Volvo Engine types are TAD734, TAD940, TAD941, TAD1640, TAD1641, and TAD1642.
Terminals of controller
Auxiliary output 1
Auxiliary output 2
CAN GND
CAN(H)
CAN(L)
Engine type: Volvo-EMS2
NOTE: When this engine type is selected, preheating time should be set to at least 3 seconds.
HGM8110DC-2 Genset Controller
HGM8110DC-2 GENSET CONTROLLER USER MANUAL
Table 43 - Connector
Connector
Expand 30A relay, and relay
offers battery voltage for
terminal14. Fuse is 16A
-
1
-
12
13
Table 44 - Engine CAN Connector
Engine's CAN port
6
5
3
4
-
1(Hi)
2(Lo)
2020-02-20
Remark
Connect to starter coil directly.
Connected to negative of battery.
CAN communication shielding line (connect
with controller's terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
ECU stop
Configurable output 1 set to ―ECU stop‖.
ECU power
Configurable output 2 set to ―ECU power‖.
Negative power
Positive power
CAN communication shielding line (connect
with controller's terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Version 1.0
Page 66 of 69