Volvo Edc4; Volvo-Ems2 - Smartgen HGM9510 User Manual

Terminals of controller
CAN GND
CAN(H)
CAN(L)
Engine type: Volvo.
NOTE: When this engine type is selected, preheating time should be set to at least 3 seconds.

16.17 VOLVO EDC4

Suitable engine types are TD520, TAD520 (optional), TD720, TAD720 (optional), TAD721, TAD722, and TAD732.
Terminals of controller
Fuel relay output
Starting relay output
CAN GND
CAN(H)
CAN(L)
Engine type: VolvoEDC4.

16.18 VOLVO-EMS2

Volvo Engine types are TAD734, TAD940, TAD941, TAD1640, TAD1641, and TAD1642.
Terminals of controller
Programmable output 1
Programmable output 2
CAN GND
CAN(H)
CAN(L)
Engine type: Volvo-EMS2.
NOTE: When this engine type is selected, preheating time should be set to at least 3 seconds.
HGM9510 Genset Parallel Controller User Manual
Table 42 "Data bus" Connector
"Data bus" connector
-
1
2
Table 43 Connector
Connector
Expanded 30A relay, and
relay offers battery voltage
for terminal 14. Fuse is 16A.
-
1
-
12
13
Table 44 Engine CAN Port
Engine's CAN port
6
5
3
4
-
1(Hi)
2(Lo)
Remark
CAN communication shielding line (connect
with controller's terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
Connect to starter coil directly.
Connected to negative of battery.
CAN communication shielding line (connect
with controller's terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
ECU stop;
Set programmable output 1 as "ECU stop".
ECU power;
Set programmable output 2 as "ECU power".
Negative power.
Positive power.
CAN communication shielding line (connect
with controller's terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Page 65 of 68