Commissioning - Smartgen HGM8140D User Manual

10 COMMISSIONING

Please make sure the following checks are made before commissioning.
1) Ensure all the connections are correct and wires diameter is suitable.
Ensure that the controller DC power has fuse, controller‟s positive and negative connected to start
2)
battery are correct.
3) Emergency stop input is connected to the positive pole of starter battery via emergency stop
button‟s normally closed point and fuse.
4) Take proper action to prevent engine to crank success (e. g. Remove the connection wire of fuel
valve). If checking is OK, make the start battery power on; choose manual mode and controller
will executive routine.
Set controller under manual mode, press "start" button, genset will start. After the cranking times
5)
as setting, controller will send signal of Start Failure; then press "stop" to reset controller.
6) Recover the action to prevent engine to crank success (e. g. Connect wire of fuel valve), press
start button again, genset will start. If everything goes well, genset will normal running after idle
running (if idle run be set). During this time, please watch for engine‟s running situations and AC
generator‟s voltage and frequency. If abnormal, stop genset and check all wires connection
according to this manual.
Choose "Auto Mode" from front panel and connect to mains signal, controller will transfer ATS(if
7)
enabled) to mains on load after "Mains Normal" delay. Genset will stop after cooling and standby
for the mains fault again;
8) If mains fault again, genset will start automatically and enter into normal running status. And then
initiate close gen command to control ATS transfers to genset on load. If not, please check ATS
controlling wiring connection according to this user manual;
If there is any other question, please contact SmartGen‟s service.
9)
HGM8140 Military Genset Controller
HGM8140 MILITARY GENSET CONTROLLER USER MANUAL
Version 1.2 2019-09-12 Page 41 of 56