9 COMMISSIONING
Before operation, the following checking should be carried out:
— Check and ensure all the connections are correct and wire diameter is suitable.
— Ensure that the controller DC power has fuse; battery positive and negative have correctly
connected.
— Set controller as Manual Mode, press
pressing
and
pressing
and
— Set controller to auto mode, automaticlly control fan on/off according to the sensor temperature.
— If there are any other questions, please contact SmartGen's service.
10 TYPICAL APPLICATION
HFC6100LT Fan Controller User Manual
. Press
to select corresponding PWM channel, speed up/down by
to adjust PWM output duty ratio.
Fig.4 - HFC6110LT Typical Application Diagram
to select corresponding fan output, fan on/off by
Page 22 of 24