Analog Devices Advantiv ADV7619 Hardware User's Manual page 188

UG-237
BG_MEAS_DONE_ST, IO, Address 0x8E[1] (Read Only)
Latched status of background port measurement completed interrupt. Once set, this bit will remain high until the interrupt has been
cleared via BG_MEAS_DONE_CLR. This bit is only valid if enabled via corresponding the INT1 or INT2 interrupt mask bit.
Function
BG_MEAS_DONE_ST
0 (default)
1
VS_INF_CKS_ERR_ST, IO, Address 0x8E[0] (Read Only)
Latched status of MPEG source InfoFrame checksum error interrupt. Once set, this bit will remain high until the interrupt is cleared via
MS_INF_CKS_ERR_CLR. This bit is only valid if enabled via the corresponding INT1 or INT2 interrupt mask bit.
Function
VS_INF_CKS_ERR_ST
0 (default)
1
CEC_STATUS1_INT_STATUS register consists of fields:

CEC_RX_RDY2_ST

CEC_RX_RDY1_ST

CEC_RX_RDY0_ST

CEC_TX_RETRY_TIMEOUT_ST

CEC_TX_ARBITRATION_LOST_ST

CEC_TX_READY_ST
CEC_STATUS2_INT_STATUS register consists of the CEC_INTERRUPT_BYTE_ST[7:0] field.
CEC_INTERRUPT_BYTE_ST[7:0], IO, Address 0x98[7:0] (Read Only)
Function
CEC_INTERRUPT_BYTE_ST[7:0]
0 (default)
1
Description
Measurements of TMDS frequency and video parameters of background port not finished or not
requested.
Measurements of TMDS frequency and video parameters of background port are ready
Description
No change in VS InfoFrame checksum error
A VS InfoFrame checksum error has triggered this interrupt
Description
No change
One of the 8 opcodes received
Rev. A | Page 188 of 204
Hardware User Guide