Eaton Power Xpert 9395P-1100/1100 Installation And Operation Manual page 90

UPS System Installation
7. Using hardware from the external wiring terminal hardware kit (see
bypass input power wiring from the utility source to the bypass input terminals in the ISBM section. See
paragraph
8. If wiring a distributed bypass system, proceed to Step 9; otherwise, proceed to Step 11.
9. Using hardware from the external wiring terminal hardware kit (see
wiring from the output terminals of each UPS unit to the customer-supplied tie cabinet or load distribution
panel. See paragraph
requirements.
10. Proceed to paragraph
11. Using hardware from the external wiring terminal hardware kit (see
3.2.4 UPS System Power Wiring
terminals to the critical load. See paragraph for wiring and termination requirements.
12. Proceed to paragraph
72 Eaton ®
3.2.4 UPS System Power Wiring Preparation
3.2.4 UPS System Power Wiring Preparation
4.8.2 Battery Power
Preparation), connect phase A, B, and C power wiring from output
4.8.2 Battery Power
Power Xpert ® 9395P-1200 Installation and Operation Manual 164000500—Rev 11
Table
for wiring and termination requirements.
Table
for wiring and termination
Wiring.
Wiring.
17), connect phase A, B, and C
17), connect phase A, B, and C