Eaton Power Xpert 9395P-1100/1100 Installation And Operation Manual page 77

the top rear and top front of the ISBM and UPM sections. Secure the brackets with the screws from the
hardware kit (see
12. Locate one flat bracket and screws from the hardware kit. Align the holes in the flat bracket over holes in
the front base of the ISBM and UPM sections. Secure the bracket with the screws from the hardware kit
(see ).Figure 23
13. Proceed to paragraph
Figure 23. ISBM Section to UPM Section Joining Brackets
Screw from Kit
Bracket from Kit
ISBM
Section Top
Top View Front Bracket
4 4 . . 4 4 E E l l e e c c t t r r i i c c a a l l l l y y C C o o n n n n e e c c t t i i n n g g t t h h e e S S e e c c t t i i o o n n s s
1. Unfasten the front door latch and swing the door open (see
2. Remove the door. Remove the retaining screw located inside the door at the bottom hinge pivot point,
then lift the door off. Retain the hardware for later use.
3. Remove the screws securing the ISBM section right bottom internal safety shield panel and remove the
panel to gain access to the internal input, output, and battery terminals. Retain the hardware for later use.
NOTE
4. Locate the AC and DC input intercabinet power wiring harnesses (long cables labeled xG1, xG2, and xG3).
Remove wire ties as necessary and uncoil the cables.
Figure 23).
4.4 Electrically Connecting the
Screw from Kit
UPM
Section Top
Front
Bracket from Kit
ISBM Section Base
Screw from Kit
AC and DC input intercabinet power wiring harnesses are supplied coiled and secured in
the UPM wireway on the left side of the UPM section (see
Eaton ® Power Xpert
Sections.
Screw from Kit
Bracket from Kit
ISBM
Section Top
Front View Base Bracket
Screw from Kit
Figure
® 9395P-1200 Installation and Operation Manual 164000500—Rev 11
UPS System Installation
Screw from Kit
Back
Top View Rear Bracket
UPM Section Base
17).
Figure 24)
UPM
Section Top
59