Installation For Inclination To The Side Or Upwards And Downwards - Pilz PSEN sc L 3.0 08-12 Series Operating Manual

Installation and alignment
8.5 Installation for inclination to the side or upwards and
downwards
}
The setting of the angle of inclination of the safety laser scanner is not changed when ex-
changing the safety laser scanner.
Prerequisites
}
PSEN sc bracket PR (see
}
Mounting surface with 2 drill holes, 10 mm deep, distance 73 mm horizontally to each
other for attaching the PSEN sc bracket PR
}
The protective bracket PSEN sc bracket H must already be attached to the safety laser
scanner (see
scanner [
Legend
[1] Adjusting disc for angle of inclination
[2] Set screw for adjusting disc for angle of inclination
[3] Fixing screws for safety laser scanner
[4] Fine adjustment screws for the incline of the safety laser scanner
[5] Front part of the PSEN sc bracket PR
[6] Fixing screws for fixing to the mounting surface
[7] Roll angle fine adjustment screws
[8] Rear part of the PSEN sc bracket PR
Procedure:
1. Loosen the roll angle fine adjustment screws [7] of PSEN sc bracket PR slightly, if re-
quired, and align the front part [5] of PSEN sc bracket PR to the rear part [8].
The bracket is pre-assembled.
2. Fix PSEN sc bracket PR with the fixing screws [6] to the mounting surface and tighten
the fixing screws [6] alternately and evenly with 3 Nm.
3. Fix the adjusting disc for angle of inclination [1] with the set screws and washers [2] on
the PSEN sc bracket PR (right or left).
4. Align the middle of the adjusting disc for angle of inclination [1] with the center of the fix-
ing for the safety laser scanner [3] and tighten the set screw for the adjusting disc for
angle of inclination [2] with 2,5 Nm.
Operating Manual PSEN sc L 3.0/5.5 08-12
1005056-EN-06
Order references [
Installation of the protective bracket PSEN sc bracket H on the safety laser
74]).
[7]
[8]
[4]
[2]
[3]
[1]
126])
[6]
[5]
[7]
[4]
[3]
| 76