Restore Configuration - Pilz PSEN sc L 3.0 08-12 Series Operating Manual

Operation
Setting
Menu item
Display settings
Reset
PSENscan
Exit
Exit menu in the display.
11.5

Restore configuration

Prerequisites
} The memory module is installed correctly.
}
The pin assignment must be compatible with the data in the memory module.
}
The correct configuration for the application is ready on the memory module.
One of the following conditions must be met.
}
The MIB files in PSEN sc L 3.0/5.5 08-12 series and in the memory module are different.
}
The topologies in PSEN sc L 3.0/5.5 08-12 seriesand in the memory module are different.
} The serial numbers saved in PSEN sc L 3.0/5.5 08-12 series and in the memory module
are different.
Procedure:
1. Switch the safety laser scanner on.
The system checks whether the conditions are met. When the conditions are met,
restoring of the configuration is started.
2. Depending on the type of difference between memory module and PSEN sc L the
restoring of the configuration varies.
Serial numbers differ: CFG NO MATCHING is shown on the display. Continue by se-
lecting the data for the restoring.
Topology or MIB files vary: WAITING CONF is shown on the display. Continue the con-
figuration in PSENscan Configurator.
3. Use the buttons on the display to select the data to be used for restore.
Display:
Restore cfg: The configuration in the memory module is used. Confirm the selection
with Confirm and the configuration is copied from the memory module into PSEN sc L.
Continue checking the configuration.
cfg from GUI: The configuration created newly in the PSENscan Configurator is used.
Confirm your selection with Confirm and continue with Create new configuration in
PSENscan Configurator.
4. Display: Confirm / Cancel
Confirm your entry with Confirm
Operating Manual PSEN sc L 3.0/5.5 08-12
1005056-EN-06
Menu second Meaning
level
Rotate The display is rotated.
Confirming starts a reset of the PSEN sc L 3.0/5.5
08-12 series.
| 106