Set The Side Inclination Of The Safety Laser Scanner - Pilz PSEN sc M 3.0 08-12 Operating Manual

Installation and alignment
If necessary, loosen the fixing screws for the safety laser scanner [3], the fine adjust-
ment screws for the inclination of the safety laser scanner [4] and the set screw for the
adjusting disc for angle of inclination [2].
Legend
[1]
[2]
[3]
[4]
2. Tighten the fixing screws for the safety laser scanner [3] with 3 Nm. Tighten the fine ad-
justment screws for the inclination of the safety laser scanner [4].
3. Tighten the set screw for the adjusting disc for angle of inclination [2] with 2,5 Nm.
7.8

Set the side inclination of the safety laser scanner

Prerequisites
}
The bracket PSEN sc bracket PR has to be installed at the mounting surface.
Procedure:
1. Change the side inclination of the safety laser scanner within the permitted range of
± 8.5°.
If required, loosen the roll angle fine adjustment screws [7] (see figure
setting of angle of inclination/roll angle - bracket PSEN sc bracket P [
2. Tighten the roll angle fine adjustment screws [7] (see figure
angle of inclination/roll angle - bracket PSEN sc bracket P [
Operating Manual PSEN sc M 3.0/5.5 08-12
1005055-EN-03
Adjusting disc for angle of inclination
Set screw for adjusting disc for angle of inclination
Fixing screws for safety laser scanner
Fine adjustment screws for the incline of the safety laser scanner
[1]
[3] [2]
[4]
Installation with
66]).
Installation with setting of
66]) with 2,5 Nm.
| 70