Distance From Walls - Pilz PSEN sc L 3.0 08-12 Series Operating Manual

Project configuration
Minimum distance from reflective surfaces
} Pilz recommends that reflective surfaces with a distance of 3 m to the safety zone are re-
moved.
If this is not possible, the allowance Z
distance.
(The recommendation was determined with a background reflection of 300
highly reflective backgrounds an additional safety assessment is required, taking into ac-
count the reflective background. This may result in a higher allowance.)
}
Objects that may be influenced by safety laser scanners through ambient light, must not
be placed within the opening angle of the laser beam.
Allowance Z
light sources or reflective surfaces
If the recommended distances cannot be met, the allowance Z
calculating the safety distance [
The value for the allowance Z
} Z = 87 mm for dust filter level = low
R
}
Z = 200 mm for dust filter level = high
R
6.10

Distance from walls

The edges of the safety zone must have a distance of 40 mm to walls or fixed objects on all
sides.
With this value, the function of the safety laser scanner is ensured. Depending on the re-
flective conditions of the walls or objects, higher allowances may be necessary (see
tance to intense light sources and to reflective surfaces [
Operating Manual PSEN sc L 3.0/5.5 08-12
1005056-EN-06
with distances below the recommended minimum distances to intense
R
33].
depends on the selected level of the dust filter.
R
INFORMATION
Determining of the allowance when the safety laser scanner has to be
installed near particularly intense or flashing light sources and a re-
flective background.
Use the higher value of the relevant allowances.
INFORMATION
Used standard value of the teach-in function for the distance from
walls
The PSENscan Configurator teach-in function uses a standard value of
100 mm. The value can be changed.
must be considered when calculating the safety
R
49]).
cd
2
m lx . For
*
must be considered when
R
Dis-
| 50