Wiring; General Guidelines; Connector Pin Assignment - Pilz PSEN sc L 3.0 08-12 Series Operating Manual

Wiring

7 Wiring
7.1

General guidelines

}
Information given in the
} Do not lay the connecting cable near or in contact with cables that carry high or highly
volatile currents.
} Use separate cables to connect the wires to the OSSDs of different safety laser scanners
or safety switches.
} For supply voltage, use only PELV/SELV power supplies that have a voltage buffer in ac-
cordance with EN 60204-1.
} The protection type (see
Pilz connection leads available as an accessory.
}
Connection to evaluation devices
– Use the cables listed in the order reference (see
– The terminals for connection to the evaluation device must be kept in a lockable con-
}
Ensure compliance with permissible cable bending radii (see
}
Do not connect outputs with test pulses to the inputs on the safety laser scanner.
7.2

Connector pin assignment

The safety laser scanner PSEN sc L 3.0/5.5 08-12 series has configurable inputs and out-
puts. In PSENscan Configurator these can be configured for the specific application.
The safety laser scanner PSEN sc L 3.0/5.5 08-12 series has an 8-pin male connector and
a 12-pin male connector for connection to the evaluation device and the supply voltage.
Use one of the two male connectors. The selected use has to be specified in PSENscan
Configurator.
Max. number
OSSD pairs
Configurable inputs
Configurable inputs/outputs
Zone sets
Operating Manual PSEN sc L 3.0/5.5 08-12
1005056-EN-06
Technical details [
Technical details [
accessories [ 126]) or equivalent cables.
trol cabinet. This prevents unauthorised modifications.
121] must be followed.
121]) can only be achieved by using the
Connection to
8-pin male connector
1
2
1
3
Order references for
Technical details [
12-pin male connector
2
1
4
10
121]).
| 63