Monitoring Of Reference Outlines; Restore Configuration - Pilz PSEN sc L 3 Series Operating Manual

Function description
4.13

Monitoring of reference outlines

An outline within the area covered by laser beams can be defined and monitored in
PSENscan Configurator as a reference outline. The outline is formed from reference points.
When PSEN sc L 3/5 series detects a change of the outline, the safety laser scanner
switches the OSSDs to the OFF state.
National and international standards recommend reference outlines for vertical applications
to reliably detect changes in the installation position of the safety laser scanners. This may
be changes due to vibration or changes due to manipulation of the safety laser scanner.
Fig.: Using of a reference outline on a passage
Legend
[1]
[2]
[3]
[4]
[5]-[8]
4.14

Restore configuration

If you experience problems with the configuration, a failed firmware update or any other
situation in which the system is no longer functional, it may be necessary to reset the sys-
tem with a different configuration.
With this function, a configuration can be adopted for further systems and therefore simplify
the configuration of further systems.
Operating Manual PSEN sc L 3/5 series
1005056-EN-01
Danger zone
Monitored safety zone
Safety laser scanner
Reference outline from the reference points [5]-[8]
Reference points
[1]
[3]
[2]
[4]
[6]
[5]
[8]
[7]
| 22