Adjusting The Centering Spring - Agilent Technologies 1200 Series User Manual

2 Installation

Adjusting the centering spring

We recommend that you make these adjustments using the 54-vial tray. This is especially
N O T E
important if you intend to use the 54-vial tray in your work.
1 Open the front door of the Well-plate Sampler.
2 Remove the plate from the transport position of the Automation Interface
3 Check that the plate slides easily left and right.
50
and place it in the rear position in the Well-plate Sampler.
If the plate does not slide easily, remove it and compress slightly the
centering spring on the rear wall. Recheck the movement.
Agilent 1200 Series Sample Capacity Extension User Manual