Setting Up The Well-Plate Handler - Agilent Technologies 1200 Series User Manual

Installation 2
Inch screws
Figure 12 Assembling the sheet metal parts
15 Set up the Agilent 1200 Series LC modules on the plastic base-plate.
At least one Agilent 1200 Series module must be placed below the sampler in the stack,
N O T E
and the maximum allowable height is two modules, each 140 mm high. If you have two
modules below the high performance autosampler, you need to set the Well-plate Handler
on four spacers.

Setting Up the Well-plate Handler

What you will need
• Phillips-head screwdriver
• small, flat-blade screwdriver
• small Phillips-head screwdriver
• 13/64 inch open-ended wrench
• Needle-nosed pliers
Agilent 1200 Series Sample Capacity Extension User Manual 19