Making The Electrical Connections - Agilent Technologies 1200 Series User Manual

Making the Electrical Connections

Ensure that the power switches of all units are OFF and that the power cords are
WA R N I N G
unplugged from the power source before proceeding.
1 Connect the fixed barcode reader cable to the port labeled Barcode Reader
2 Connect the CAN Cable from the Automation Interface to one of the other
3 Connect the auxiliary power cable from the Automation Interface to any
Figure 28
4 Remove the protection cap of the RS-232 port of the Well-plate Sampler.
5 Connect the RS-232 cable from the Well-plate Sampler (female connector)
Agilent 1200 Series Sample Capacity Extension User Manual
Rear on the Automation Interface (see
Agilent 1200 Series modules (see
Agilent 1200 Series module with a free power outlet (see
Connections to the automation interface and high performance autosampler
to the C-Port of the Well-plate Handler (male connector). See
Figure 28).
Figure 28).
Installation 2
Figure 28).
Figure 29.
35