Installing The Optional Hand-Held Barcode Reader - Agilent Technologies 1200 Series User Manual

2 Installation
3 Install the barcode reader and its mounting plate on one of the three

Installing the Optional Hand-held Barcode Reader

The hand-held barcode reader is connected between the computer keyboard
and the computer.
The hand-held barcode reader is designed for connection to a keyboard with a mini-DIN
N O T E
connector. If your keyboard uses a USB connector, you need to use an adapter to convert
the USB plug to a mini-DIN plug.
1 Shut the computer down, if necessary.
2 Unplug the keyboard connector from the rear panel of the computer.
3 Plug the male connector of the hand-held barcode reader into the keyboard
4 Plug the keyboard connector into the free female connector of the
5 Restart the computer.
Configuring the Hand-held Barcode Reader
The hand-held barcode reader is preconfigured to read the following barcode
types:
32
positions at the rear of the Automation Interface, and remove the
protection film.
Three positions are available on the rear of the Automation Interface; the
position you select will depend on where you place the barcodes on the
plates.
socket on the rear panel of the computer.
hand-held barcode reader.
• Code 128
• Code 39 (without checksum)
• Code 2 of 5 interleaved (without checksum)
• Codabar (without transfer of start/stop)
Agilent 1200 Series Sample Capacity Extension User Manual