Agilent Technologies 1200 Series User Manual page 62

3 G2257A Software Navigation
All racks must be of the same type.
N O T E
Well-plate Rack In the Well-plate Rack Extension group, you specify whether a Rack Extension,
Extension
giving you three additional racks, is installed or not.
Lids In the Lids group, you specify whether lids are used on the top plate of the
input rack(s), on the top plates of both input and output racks, or not at all. If
lids are used, you must specify the dimensions in the Lid Heights group.
Lid Heights If you use lids, you must specify both the Incremental Height (the additional
height the lid adds to the height of the plate) and the Lid Height (the total height
of the lid).
Measuring lid heights
Incremental height
Lid
Plate
Figure 39
Incremental 1 Place the well-plate on the bench and measure its height (H1).
Height
2 Place the lid on the well-plate and measure the total height (H2).
62
Well-plate and lid heights
Agilent 1200 Series Sample Capacity Extension User Manual
Lid height
H2
H1