Install The Micro Well-Plate Sampler (G1377A) - Agilent Technologies 1100 Series System Manual

Connect the power cable to power only after you have finished the hardware

Install the Micro Well-plate Sampler (G1377A)

WARNING
installation of all modules in the stack.
1 Ensure the line power switch at the front of the micro well-plate sampler ( micro
2 Place the micro WPS on top of the TCC. Make sure that the two modules are
3 Remove the sampler shipping protection foam.
4 Connect the CAN-bus cable (5181-1519) to one of the CAN connectors at the rear
5 Connect the power cable to the power socket at the rear of the micro WPS. Do not
6 Connect the free end of the Can-bus cable from the TCC to the unused Can-bus
7 Connect one end of the sampler-to-column capillary (G1375-87304) to port 6 of the
1100 Series Capillary LC System Manual
WPS) is off.
interlocked correctly.
of the micro WPS.
connect the power cable to power until you have finished the hardware installation
of all modules in the stack.
connector at the rear of the micro sampler.
sampler injection valve. Connect the other end of this capillary to the inlet of the
Installing your Capillary LC System 1
9