Power Off The Library - Spectra Logic T-Series Spectra T200 User Manual

6. Use the Select a command to send drop-down list to select Prepare Robot For
Service [M].
7. Use the Select a target controller drop-down list to select Motion Control.
8. Select Run Utility.
A progress screen displays. When the operation is complete, a Utility Results screen
displays. The transporter is now parked in an accessible position.

Power Off the Library

1. Power off the library as described in Power Off the Library on page 21.
2. Set the main power switches (Figure 9-6) on the library back panel to the off
position.
Note:
If you have redundant power supplies installed, make sure you
turn off both power switches.
Figure 9-6 The main AC power switches and connectors.
3. Disconnect the AC power cords from the library.
Note:
With cable locks installed on the power cords, it may be easier to
disconnect the cords from the AC outlets at the wall. If you have
redundant power supplies installed, make sure you disconnect
both power cords.
Main AC switches
Power Off the Library
77