Chapter 7 - Replacing A Power Supply Module; Before You Begin; Required Tools And Materials - Spectra Logic T-Series Spectra T200 User Manual
Assisted self-maintenance guide
Hide thumbs
Also See for T-Series Spectra T200:
- User manual (402 pages) ,
- Release note (50 pages) ,
- Supplementary manual (50 pages)
Table of Contents
Advertisement
7
Replacing a Power Supply
Module
Before You Begin
The power supply modules supply DC power to the library's drives and QIPs.
Note:
Power supply modules are mounted vertically in the bays at the
bottom of the chassis. The mounting plate for each module is at
the top. The power supply module in Figure 7-1 is shown in a
horizontal position for reference only.
Figure 7-1
Required Tools and Materials
You must have the following to complete this procedure:
A #2 Phillips screwdriver
A new power supply module
Note:
After removing the new power supply from its packaging, keep the
packaging for returning the old power supply to Spectra Logic.
A power supply module.
v
63
Mounting plate
Advertisement
Table of Contents
Need help?
Do you have a question about the T-Series Spectra T200 and is the answer not in the manual?