Spectra Logic T-Series Spectra T200 User Manual page 35

3. Select Configuration > Drives. The Drives screen displays.
4. Based on the drive identifier you determined in Identifying the Malfunctioning
Drive on page 33, select Replace for the drive that you want to replace.
A Feedback Required screen prompts you to confirm that you want to replace the
drive.
Caution:
Do not select Remove. This option permanently removes the
drive from the partition. When the replacement drive is
installed, it will not be assigned to the partition from which the
malfunctioning drive was removed.
If you select Remove and the selected drive is the only drive in
the partition, the partition will be deleted.
5. Select OK.
Another Feedback Required screen indicates that the requested drive has been
successfully shut down.
Note:
Do not respond to the prompt in the Feedback Required screen or
perform any other operations from the user interface (either locally
or remotely) until you complete the replacement procedure.
Responding before you replace the drive will power on and
configure the drive you just powered down.
Figure 4-3 The Drives screen.
Preparing the Library
35