Ptp License Management - Safran WR-Z16 User Manual

Unicast Negotiation
Delay Mechanism
Network mode
Domain
Announce ratio
Sync ratio
Delay Req ratio
Advanced Settings
Offset correction
Servo Fit Algorithm
5.4.1.1

PTP license management

All the topics related to PTP license management such as purchasing, activating
and checking are explained within the Licenses section
Once the license is activated (see image below) the web interface should allow
the user to configure these settings as explained in
page.
Figure 5-14:
CHAPTER •
5 WR-Z16 User Manual Rev. v5.0
PTP
Enabled or Disabled
End to End (E2E) or Peer to Peer (P2P)
IPv4 or Ethernet (layer 2)
0-255
[1 msg/128s, 16 msg/s] ([-7,4])
[1 msg/128s,128 msg/s] ([-7,7])
[1 msg/128s,128 msg/s] ([-7,7])
Any number (in nanoseconds)
Normal, Soft, Hard, Hardx2
Unlicensed VS Licensed PTP daemon
Note: The CLI tool allows to modify and save all the parameters lis-
ted in "IEEE 1588 configuration with/without license" on the previous
page even without
Applied/Loaded until the PTP license is validated.
With License
license. However,
5.4 IEEE 1588-2008 (PTPv2)
Without License
Disabled
End to End (E2E)
IPv4
0
1 msg/s
1 msg/sec
1 msg/sec
0
Normal
("Licenses" on page 138).
"Configuration" on the next
they will not be
75