Safran WR-Z16 User Manual page 109

The WR-Z16 includes the possibility of activating HTTPS. This can be done from
the web interface by following the next steps:
The options about HTTPS can be accessed under Administration > Security >
HTTP/HTTPS Configuration as shown in the figure below:
Figure 6-1:
The option selected by default is HTTP. While this option is active, the contents
are transmitted in plain text.
In order to use the secure mode, it is necessary to either use an already-existing
certificate or generate a new one. In the HTTPS Mode drop-down menu, select
Uploaded to upload a certificate. Select Generated to generate a certificate,
download a generated certificate, and to download a root certificate.
Finally, the last section of the HTTP/HTTPS menu enables Diffie-Hellman para-
meters in the TLS key exchange. This is optional but recommended. There are
two buttons to generate and download the DH parameters file.
CHAPTER •
6 WR-Z16 User Manual Rev. v5.0
Security-HTTP/HTTPS menu of Web Interface.
Caution:
Once the secure mode has been activated, an info message
will be shown advising that the next connection will be done on
HTTPS. After rebooting the device, the HTTP port will be redirected
to HTTPS. There is a possibility to completely disable port 80, but be
careful because if HTTPS is not configured, the web access will be
lost and the only way to enable it again will be using CLI.
6.2 HTTPS
99