Table of Contents
Advertisement
4.3 The Web GUI
2.
3.
4.
5.
6.
44
Figure 4-4:
Web GUI Network Page Navigation
From the Interfaces tab, identify the port you wish to configure. If DHCP is
enabled, the values will be read-only. To disable DHCP, select the no radio
button. It will then be possible to fill in your network information.
Figure 4-5:
Disable DHCP via the Web GUI
After entering your chosen static IP address and networking information,
select the Save Configuration button at the bottom right of the page.
A green confirmation banner will acknowledge your save; you will also see
a warning that the saved changes will not be applied to the functionality
until the unit is rebooted:
Figure 4-6:
Network change banners at the bottom of the page
Once you have made your desired changes, you can either select the
Reboot button from the warning banner, or navigate to Management >
Maintenance and select the device Reboot button.
Your changes can be confirmed from the dashboard (which lists all inter-
face IP addresses in the Network Status Panel) or you can also return to the
Administration > Network page.
CHAPTER
•
4
WR-Z16 User Manual Rev. v5.0
Advertisement
Table of Contents
