Network Configuration From Cli - Safran WR-Z16 User Manual

4.4.1

Network configuration from CLI

To illustrate the usage of wrz_config tool, the configuration of the network inter-
face is detailed as a step-by-step procedure. The behavior can then be emulated
in other menus in the configuration tool.
To set the IP address for the eth0 management interface:
CHAPTER •
4 WR-Z16 User Manual Rev. v5.0
Caution:
Avoid manual editing of .config file: In order to avoid errors such as
duplicated entries, it is not recommended to manually edit the
/root/.config. This might have been suggested for some specific con-
figurations of the previous version (WRZ-OS v2.x) but this practice is
now discouraged.
1. The first step is to execute the wrz_config command from a terminal.
2. Then, the Network section must be selected from the main menu:
.
3. Then the corresponding network interface (eth0) to be modified must be
selected:.
Figure 4-8: wrz_config interface. Network interfaces to change
4. If the static IPv4 settings must be loaded, disable DHCP
4.4 CLI Configuration
47