Safran WR-Z16 User Manual page 74

5.2 General Timing Management
5.
6.
Custom Preset via the CLI
As shown in
the preset=Custom to reveal the Ports Configuration submenu and other para-
meters.
Figure 5-6:
Then each port can be configured independently with:
64
that interface. The Mode field options will be determined by selections in
the Protocol field.
After entering your information, select the Save Configuration button in the
lower right of the window. (In order to test functionality, you may select
Apply Configuration instead. This setting will not be persistent across
reboots unless the configuration is also saved and the unit is rebooted).
You will see a save confirmation banner and a warning that the saved
changes will not be applied until the next reboot.
Once you have made your desired changes, you can either select the
Reboot button from the warning banner, or navigate to Management >
Maintenance and select the device Reboot button.
Note:
CLI and Custom Preset: The steps to follow in wrz_config (CLI)
are slightly different than in the web as it is needed to select the Cus-
tom Preset to bring up the corresponding subset of parameters to
the menu. If the Custom preset is not chosen in advance, these para-
meters will stay hidden and thus not configurable.
"Custom Preset with CLI tool"
Custom Preset with CLI tool
Protocol: WR, PTP, NTP, Disabled
Role: Master, Slave, Auto , Survey
Source Rank: [0-255], Order the timing source given the source rank pri-
orities where:
below, the user first needs to select
CHAPTER •
5 WR-Z16 User Manual Rev. v5.0