Info/Overview - Safran WR-Z16 User Manual

5.7.2

Info/Overview

An overview of the holdover timing source is provided to monitorize its state at
any time as shown in
If its state is UNAVAILABLE this means that the holdover oscillator has not been
detected and its related information in irrelevant. If you have ordered the hold-
over option but the device does not detect it, please contact
on
Figure 5-18:
3.7220.x
3.7220.2
3.7220.0
3.7220.1
CHAPTER •
5 WR-Z16 User Manual Rev. v5.0
"Holdover overview"
page 160.
Holdover overview
OID Name
holdover/info/xxx
State
Time Learning
Time Holdover
below.
Value Type
Information about the Hol-
dover timing source
<Enum> Current state of the holdover timing
0. UNAVAILABLE source as explained in the intro-
1. DISABLED duction of the section. If the holdover
2. LOCKING is not detected the corresponding
3. LEARNING state if UNAVAILABLE. The user can
4. READY also manually force it as DISABLED in
5. ACTIVATED case to avoid triggered it.
6. EXPIRED
<Integer> Time the holdover has been in
LEARNING state (in seconds)
<Integer> Seconds elapsed since holdover activ-
ation
5.7 Holdover
"Technical Support"
Description
93