Table of Contents
Advertisement
The SecureSync unit will install into any EIA standard 19-inch rack. SecureSync occupies
one rack unit of space for installation, however, it is recommended to leave empty space of
at least one rack unit above and below the SecureSync unit to allow for best ventilation.
Rack mounting requirements:
2.5.1
Rack Mounting (Ears)
The SecureSync
The 2400-0000-0704 ruggedization ancillary kit (optional) contains additional mounting
items available for purchase:
The following customer supplied items are also needed:
SecureSync 2400 Getting Started Guide Rev. 4
Caution:
For safety reasons the SecureSync unit is intended to be operated
in a HORIZONTAL POSITION, RIGHT-SIDE-UP.
The maximum
ambient operating temperature
If the SecureSync unit is to be installed in a closed rack, or a rack with large amounts
of other equipment, a
rack cooling fan
installation.
Installation of the unit in a rack should be such that the amount of
for safe operation of the equipment is not compromised.
Follow the mounting directions described below to
loading, possibly resulting in a hazardous condition.
Do not overload power supply
overload protection. For power requirements, see
Reliable
of rack-mounted equipment must be maintained. Particular
grounding
attention must be given to supply connections other than direct connections to the
branch circuit (e.g., use of power strips).
ancillary kit
2 each 2400-1000-0714 equipment rack mount ears
6 each HM20R-04R7-0010 M4 flat head Phillips screws
2 each 2400-1000-0706 rear rack mount ears
2 each HM20R-04R7-0010 M4 flat head Phillips screws
4 each #10-32 pan head rack mount screws
1 each #2 Phillips head screwdriver
1 each 3/32" straight screwdriver
or fans should be part of the rack mount
circuits. Use only supply circuits with adequate
contains the following parts needed for rack mounting:
2.5 Mounting the Unit
must be observed.
air flow
prevent uneven mechanical
"Input Power" on
page 13.
required
21
Advertisement
Table of Contents
