Important Safety Notes For Residential Sectional Type Doors Only Please read the instructions carefully! This garage door operator is designed to provide safe and reliable service if installed and tested as described in these instructions. A garage door is the largest mechanical appliance in a residence. Care must be taken to prevent injury or death during installation and operation of the garage door and garage door operator.
Using the Garage Door Operator IMPORTANT USER SAFETY INSTRUCTIONS WARNING A MOVING GARAGE DOOR CAN CAUSE INJURY OR DEATH! TO REDUCE THE RISK OF DEATH OR SEVERE INJURY: READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS. NEVER LET CHILDREN OPERATE, OR PLAY WITH DOOR CONTROLS! KEEP REMOTE CONTROL AWAY FROM CHILDREN! Always keep moving door in sight and away from people and objects until it is completely closed.
They can close the door, but not open it once closed. The door can still be opened or closed by using the wall station pushbutton or via the Nice G.O. app. NOTE: To indicate that the Vacation Lock is enabled, the blue arrows will flash.
Adjusting the Open and Close Limits The limit settings control how far the door will open and close. Set the limits so the door opens just short of any door stops, and closes at the floor level. Out of the box, the operator is preset on its close limit and the open limit is preset for a 7-foot high door. Use the wall station or a transmitter to test operate the door.
Safety Reversal System Test The operator determines if there is an obstruction if a higher than expected amount of force is detected during a door cycle. If an obstruction is encountered during a closing cycle, the operator and door will stop then fully open. If an obstruction is encountered during an opening cycle, the operator and door will stop.
Remote Controls The operator is supplied with a three-button remote control (the second and third buttons can be used to control an additional operator or gate if it contains a Linear MegaCode™ receiver). Additional single and multi-button, remote controls, keypads, and external receivers can be purchased. WARNING Children operating or playing with a garage door operator can injure themselves or others.
Testing a) Stand clear of the door, press the remote control’s button and verify that the operator starts. PRESS THE REMOTE CONTROL’S BUTTON AGAIN TO STOP THE DOOR MID-TRAVEL. Replacing a Remote Control’s Batteries When the BLUE light on the remote glows dimly, or fails to light at all when the remote is activated, the batteries need replacing.
Connect your Opener to the Nice G .O . app Stand near Wi-Fi wall station. On your mobile device in the Nice G.O. app, tap the plus sign at the bottom right of screen to Connect Your Device. Follow directions in app to Connect Your Device.
Setting Up the Wall Station This Wall Station controls operation of the door and light using the buttons. When paired with the Nice G.O. smartphone app, you can control the garage door(s) from any location, invite and manage other users’ app and operator access, control the lights, schedule operator events and be alerted of all garage door activities.
Garage Door Operator Maintenance Weather conditions may affect the door operation which could require some re-setting of the operator’s adjustments. Doors may swell and become heavier during wet periods, door hinges and rollers might bind during cold periods. To insure safe operation of the door, perform the following tests, including any additional test steps described.
Checking for Reversal DOWN a) With the door closed and the operator disengaged from the door, press the wall station button to move the traveler (the part on the belt or chain that the trolley engages with) to the up position TOWARD (away from the door).
Chain Adjustment If necessary, use the following steps to adjust the chain. CHAIN TIGHTEN a) Hold the turnbuckle with a flat blade screwdriver, and loosen the two CHAIN LOOSEN lock-nuts with a 7/16” end wrench. LOCKNUTS b) Twist the turnbuckle to adjust the chain tension. Adjust the chain until the LOOSEN turnbuckle is sightly above the rail.
This product is warranted to the original consumer against defects in material and workmanship for the periods mentioned above. Nice North America will repair, or at its option, replace, any device that it finds requires service under this warranty, and will return the repaired or replaced device to the consumer at Nice North America’s cost.
Page 16
REGULATORY INFORMATION We, Nice North America LLC of 5919 Sea Otter Place, Carlsbad, CA 92008, declare under our sole responsibility that the device, LINEAR600 complies with Part 15 of the FCC rules. FCC & IC Notice This device complies with Part 15 of the FCC Rules and Industry Canada license exempt standard(s). Operation is subject to the following two...
Need help?
Do you have a question about the Linear 661 and is the answer not in the manual?
Questions and answers