Stand-Alone Operation With Single External Power Supply: Minimum Configuration - Renesas RH850/U2A 292pin User Manual

RH850/U2A 292pin
8.2.3

Stand-Alone Operation with Single External Power Supply: Minimum Configuration

This example enables to operate the board with only the 3.3 V external power supply.
Since no 5 V voltage is available, all I/O ports can only use 3.3 V.
•
CN8: GND connection
•
CN9: not connected, no 5.0 V
−
jumpers JP2, JP3, JP6 to JP14, JP22 and JP32 to JP37 are set to 3.3 V position [2-3]
•
CN10: 3.3 V
•
CN11: not connected, no IN_1v12
−
JP16[2-1]: use reg_vcc_VDD from on-board voltage regulator for supply of VDD voltage
−
VDD from reg_vcc_VDD (JP23[2-1]) or from SVR_OUTPUT (JP23[2-3]) from on-chip Switching Voltage
Regulator
Refer to 3.3 Device Core Voltage (VDD) Selection for further details about VDD voltage.
Figure 8.1 Stand-alone operation with minimum external power supply
R20UT4545ED0102 Rev.1.02
May 27, 2021
2 3
2 3
3 2
3 2
3 2
3 2
3 2
8. Jumper Configuration Examples
3 2
3 2
3 2
3 2
3 2
3 2
2 1
2 1
Page 43 of 58