2.3
Basic Settings
Set the network configurations, network topology, or other parameters for the Motion module.
Item
Description
Network Configuration
Set the CC-Link IE TSN network configuration.
Settings
*1
Refresh Settings
Assign link refresh ranges between the devices described below.
• SB, SW, link devices (RX, RY, RWr, RWw) of the Motion module Devices of
Network Topology
Select the network topology type according to the actual network configuration.
Communication Period Setting
Set the basic cycle setting and multiple cycle setting.
Connection Device
Set the information of connected devices.
Information
Device Station Setting
Set the number of consecutive communication failures until a device station is
considered disconnected.
Safety Communication
Set whether to use the safety communication or not and set the safety connections
*2
Setting
and the transfer ranges of safety devices.
*1 When using the PLCopen Motion control FB mode, when the version of Add-on baseSystem is "1.18" or earlier, this setting is treated to
be not set.
*2 This item can be set only in a project of the Safety CPU.
the CPU module
Reference
Page 112 "CC-Link IE TSN
Configuration" Window
Page 100 Refresh Settings
Page 102 Network Topology
Page 102 Communication Period
Setting
Page 103 Connection Device
Information
Page 104 Device Station Setting
Page 104 Safety Communication
Setting
2 PARAMETER SETTINGS
2.3 Basic Settings
2
99