Parameter processing of a device station
The processing is to read and save the parameters from the device station, and to write the saved parameters to the device
station.
Also, it automatically sets parameters of the device station from the master station. (Page 91 Device station parameter
automatic setting)
When performing the parameter processing to the main module to which the extended module is connected,
use the following module.
• Motion module whose Add-on baseSystem version is "1.16" or later
For MR-J5(W)-G
Navigation window "Parameter" "Module Information" Target module "Module Parameter (Network)" "Basic
Settings" "Network Configuration Settings" <Detailed Setting>
Select "Parameter Automatic Setting" <Detail Setting> to display the "Parameter Setting" window.
2 PARAMETER SETTINGS
120
2.5 "CC-Link IE TSN Configuration" Window