Mitsubishi Electric MELSEC iQ-R Series User Manual page 149

The following restrictions are applied when starting the CC-Link IE TSN/CC-Link IE Field diagnostics with
"Other Station (Single Network)" or "Other Station (Co-existence Network)" specified in "Other Station Setting"
on the "Specify Connection Destination Connection" window.
• The communication test cannot be used.
• The station information list cannot be used.
• The diagnostics cannot be started when MELSECNET/H, multidrop connection of the serial communication
module, interface board for personal computer, GOT (transparent function used), or MELSEC-Q/L series
network module is on the communication path.
When specifying "Other Station (Co-existence Network)" in "Other Station Setting" on the "Specify Connection
Destination Connection" window, the diagnostics cannot be started with "CC-Link" or "C24" specified in "Co-
existence Network Route".
Usage methods
The following describes how to use the CC-Link IE TSN/CC-Link IE Field diagnostics.
■ When "No Specification" is specified in "Other Station Setting" on the "Specify Connection
Destination Connection" window
1.
Connect the engineering tool to the CPU module.
If a device station cannot be monitored due to an error such as cable disconnection, directly connect the engineering tool to
the device station.
2.
Start the CC-Link IE TSN/CC-Link IE Field diagnostics.
[Diagnostics]  [CC-Link IE TSN/CC-Link IE Field Diagnostics]
3.
When the following window opens, select the Motion module to be diagnosed and click the [OK] button to start the CC-
Link IE TSN/CC-Link IE Field diagnostics.
Modules are listed in the order configured in module information.
4.
Select the station to be diagnosed from "Select Station" or in the network map.
Network map
In this manual, "Authentication Class" is written as "CC-Link IE TSN Class".
Disconnected
station
4.3 Checking the Network Status
4 TROUBLESHOOTING
147
4